![]() ![]() (default 128) Maximum number of characters per line in dump mode. (default 256) Maximum number of characters in serial IRQ buffer (should always be larger than SML_BSIZ and even larger on high baud rates).can now be defined per meter in descriptor, see special options Decrease this to 1 for example if you have a meter with many lines and lots of characters per descriptor line. can now be defined per meter in descriptor, see special options Complete chunk of serial data must fit into this size, so include any CR/LF if that applies. (default 48) Maximum number of characters per line in serial input buffer. ![]() Most features are now enabled by default, others may be set in the descriptor per meter. These parameters are explained further below in the article. #ifndef USE_SCRIPT #define USE_SCRIPT #endif #ifndef USE_SML_M #define USE_SML_M #endif #ifdef USE_RULES #undef USE_RULES #endifĪdditional features can be enabled by adding the following #define compiler directive parameters and then compiling the firmware. Smart Home Integrations Smart Home Integrations.AEConversion solar inverter INVXXX (RAW).Elster F96 Plus (Sharky 775) (Ditech Integral-V UltraLite PRO) M-Bus.ABB B-Series (like B21, B23) (M-Bus over Infrared port).Smart Meter Interface Smart Meter Interface Table of contents. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |